last update of this ad was on Tue May 27 2008

Call (336)-408-8451 in Winston Salem NC

[ Click Here for Pics ]

1997 Polaris 780 SLT 3 seater jet ski. Was purchased in 1997 new and was last ran in 2001. Was kept in owners basement after he passed away until I purchased this year. Has been serviced and a new battery installed. Paint and decals still look new. Runs good and is ready to go in the water. Call Clayton Auto Sales at 336 408-8451 to purchase. 2003-2004 Chevrolet Silverado 1500 - 2WD - 4 Door Hd, 2 Wheel Steering
Rear Performance Ceramic Hawk Brake Pads - Performance Ceramic Ultimate stopping power in an ultra-low dust, low noise ceramic compound! Hawk Performance has introduced a premium, high performance, ultra-low dust, low noise compound called Performance Ceramic. Performance Ceramic is engineered to reduce brake NVH (Noise, Vibration and Harshness), creating a quieter performing brake pad. Furthermore, the ceramic brake pad formula has a linear friction profile that allows your ABS brake system to work more effectively. With Performance Ceramic you can expect reduced brake pad wear, lower dust output levels and a rotor-friendly brake pad. Performance Ceramic ? quiet, clean & fast stopping! Key Features: ? Increased stopping power ? Increased rotor life ? Extended pad life ? Ultra-low dust ? Extremely quiet ? Stable friction output ? Recommended for import domestic automobiles, luxury SUV?s, sports trucks & vans. Today?s alloy wheel designs on premium vehicles has contributed to customer demand for a low dust performance brake product. Specify Hawk Performance?s Performance Ceramic brake pads for your luxury car, SUV, or truck. All Hawk Performance Performance Ceramic brake pads provide a limited lifetime warranty, ensuring products to be free of defects from manufacturer?s workmanship and materials. Note: Hawk Performance burnishes its Performance Ceramic brake pads as a final step in the factory, but all brake pads have to be bedded-in with the rotors (new or used) that they will be used against. Properly bedding-in new brake pads results in a transfer film being generated at the pad and rotor interface to maximize brake performance Brake Pad Installation Procedure 1. Install brake pads properly. Be sure pads are securely positioned in the caliper. 2. Flush system with fresh brake fluid. 3. Check all hydraulic parts for excess wear and tear. 4. Check disc for proper thickness, parallelism, and lateral runout. 5. Check disc for scoring or grooves over .012?depth. If either applies, resurfacing is required. 6. If discs do not need resurfacing, then contamination from the previous brake pads must be removed. Sand discs with 130 grit sandpaper using moderate pressure. Use soap and water to clean discs? surface after sanding and machining. Discs should be free and clear of oil, grease, and brake fluid. 7. Inspect calipers for freedom of movement. Lubricate where necessary. Burnishing Instructions 1. After installing new brake pads, make 6 to 10 stops from approximately 30-35 mph applying moderate pressure. 2. Make an additional 2 to 3 hard stops from approximately 40 to 45 mph. 3. DO NOT DRAG BRAKES! 4. Allow 15 minutes for brake system to cool down. 5. After step 4 your new pads are ready for use.

,